I'm using SetupBuilder to build and protect my application from the command line. The application is protected correctly but I don't see any log in the command line.

<< Click to Display Table of Contents >>

Navigation: WinLicense > FAQ > General >

I'm using SetupBuilder to build and protect my application from the command line. The application is protected correctly but I don't see any log in the command line.

WinLicense will display a log with all the protection steps when you protect under Windows XP or higher.

If you want to display the log from SetupBuilder, you can write a batch file to call WinLicense and issue a "#run winlicense.bat". This will open the command window and the log will be seen.

The winlicense.bat file will contain:

WinLicense.exe /protect YouProjectName